применил все способности)))
вот что написанно в install:
Module compile outside the kernel tree but need the source of your running
kernel installed and configured.
be sure your kernel include usb and v4l stuff
Kernel 2.4.x
configure your kernel
make dep
go to the spca5xx directories
make clean (to be sure)
make
if all goes right as root :
make install
Kernel 2.6.x
make clean
make
if all goes right as root :
make install
To test please use the command line spcaview tool.
You need libsdl installed with the header from your distro or goto
http://www.libsdl.org/*******************************************************************************************/
SPCAVIEW is the only V4L1 Apps for testing your SPCA5XX webcam.
IF THAT WORK WITH SPCAVIEW ALL OTHERS V4L1 APPS SHOULD WORK !!!
DON'T ASK ME ABOUT :
XAWTV GNOMEMEETING MOTION EKIGA AMSN ZONEMINDER CAMORAMA CAMSTREAM
VIDEODOG PALANTIR SPOKE CAMSOURCE MPLAYER VLC FFMPEG MPEG4IP .....
ASK THE AUTHORS. YOU SHOULD GET A BETTER ANSWER !!!
/*******************************************************************************************/
plug the cam
as root :
lsmod
spca5xx should be load with videodev, if not, somethings goes wrong,
verify that your cam is supported if not and you are sure for a Sunplus
chip goto irc.freenode.net channel #spca50x and ask for help
if yes run spcaview with this parameters (maybe read the readme is the
best)
spcaview -d /dev/video0 -f yuv
if you have a bttv card use change the video0 to video1
that should work
Enjoy !!
а в redmy много написанно но там ни чего интересного! я точно знаю)))
Тема: tar. gz -как использовать (Прочитано 10597 раз)
