smartctl version 5.38 [i686-pc-linux-gnu] Copyright (C) 2002-8 Bruce Allen
Home page is
http://smartmontools.sourceforge.net/=== START OF INFORMATION SECTION ===
Model Family: Seagate Barracuda 7200.9 family
Device Model: ST3200827A
Serial Number: 5ND35ZS1
Firmware Version: 3.AAE
User Capacity: 200 049 647 616 bytes
Device is: In smartctl database [for details use: -P show]
ATA Version is: 7
ATA Standard is: Exact ATA specification draft version not indicated
Local Time is: Wed Mar 17 20:42:19 2010 MSK
SMART support is: Available - device has SMART capability.
SMART support is: Enabled
=== START OF READ SMART DATA SECTION ===
SMART overall-health self-assessment test result: PASSED
See vendor-specific Attribute list for marginal Attributes.
General SMART Values:
Offline data collection status: (0x82) Offline data collection activity
was completed without error.
Auto Offline Data Collection: Enabled.
Self-test execution status: ( 0) The previous self-test routine completed
without error or no self-test has ever
been run.
Total time to complete Offline
data collection: ( 430) seconds.
Offline data collection
capabilities: (0x5b) SMART execute Offline immediate.
Auto Offline data collection on/off support.
Suspend Offline collection upon new
command.
Offline surface scan supported.
Self-test supported.
No Conveyance Self-test supported.
Selective Self-test supported.
SMART capabilities: (0x0003) Saves SMART data before entering
power-saving mode.
Supports SMART auto save timer.
Error logging capability: (0x01) Error logging supported.
General Purpose Logging supported.
Short self-test routine
recommended polling time: ( 1) minutes.
Extended self-test routine
recommended polling time: ( 70) minutes.
SMART Attributes Data Structure revision number: 10
Vendor Specific SMART Attributes with Thresholds:
ID# ATTRIBUTE_NAME FLAG VALUE WORST THRESH TYPE UPDATED WHEN_FAILED RAW_VALUE
1 Raw_Read_Error_Rate 0x000f 117 082 006 Pre-fail Always - 120316408
3 Spin_Up_Time 0x0003 098 098 000 Pre-fail Always - 0
4 Start_Stop_Count 0x0032 100 100 020 Old_age Always - 942
5 Reallocated_Sector_Ct 0x0033 100 100 036 Pre-fail Always - 0
7 Seek_Error_Rate 0x000f 086 060 030 Pre-fail Always - 4704639120
9 Power_On_Hours 0x0032 075 075 000 Old_age Always - 22164
10 Spin_Retry_Count 0x0013 100 100 097 Pre-fail Always - 0
12 Power_Cycle_Count 0x0032 099 099 020 Old_age Always - 1632
187 Reported_Uncorrect 0x0032 100 100 000 Old_age Always - 0
189 High_Fly_Writes 0x003a 100 100 000 Old_age Always - 0
190 Airflow_Temperature_Cel 0x0022 059 044 045 Old_age Always In_the_past 41 (0 2 46 25)
194 Temperature_Celsius 0x0022 041 056 000 Old_age Always - 41 (0 19 0 0)
195 Hardware_ECC_Recovered 0x001a 053 046 000 Old_age Always - 106824267
197 Current_Pending_Sector 0x0012 001 001 000 Old_age Always - 4294967295
198 Offline_Uncorrectable 0x0010 001 001 000 Old_age Offline - 4294967295
199 UDMA_CRC_Error_Count 0x003e 200 190 000 Old_age Always - 31
200 Multi_Zone_Error_Rate 0x0000 100 253 000 Old_age Offline - 0
202 TA_Increase_Count 0x0032 100 253 000 Old_age Always - 0
SMART Error Log Version: 1
ATA Error Count: 115 (device log contains only the most recent five errors)
CR = Command Register [HEX]
FR = Features Register [HEX]
SC = Sector Count Register [HEX]
SN = Sector Number Register [HEX]
CL = Cylinder Low Register [HEX]
CH = Cylinder High Register [HEX]
DH = Device/Head Register [HEX]
DC = Device Command Register [HEX]
ER = Error register [HEX]
ST = Status register [HEX]
Powered_Up_Time is measured from power on, and printed as
DDd+hh:mm:SS.sss where DD=days, hh=hours, mm=minutes,
SS=sec, and sss=millisec. It "wraps" after 49.710 days.
Error 115 occurred at disk power-on lifetime: 20352 hours (848 days + 0 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
84 51 00 00 00 00 e0 Error: ICRC, ABRT at LBA = 0x00000000 = 0
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
25 00 01 73 d0 70 e0 00 00:01:00.392 READ DMA EXT
25 00 01 72 d0 70 e0 00 00:01:00.374 READ DMA EXT
25 00 01 71 d0 70 e0 00 00:01:00.366 READ DMA EXT
00 00 01 00 00 00 00 04 00:00:59.917 NOP [Abort queued commands]
25 00 01 71 d0 70 e0 00 00:00:59.900 READ DMA EXT
Error 114 occurred at disk power-on lifetime: 20352 hours (848 days + 0 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
84 51 00 00 00 00 e0 Error: ICRC, ABRT at LBA = 0x00000000 = 0
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
25 00 01 71 d0 70 e0 00 00:01:00.392 READ DMA EXT
25 00 01 70 d0 70 e0 00 00:01:00.374 READ DMA EXT
25 00 01 6f d0 70 e0 00 00:01:00.366 READ DMA EXT
25 00 01 6e d0 70 e0 00 00:00:59.917 READ DMA EXT
00 00 01 00 00 00 00 04 00:00:59.900 NOP [Abort queued commands]
Error 113 occurred at disk power-on lifetime: 20352 hours (848 days + 0 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
84 51 00 00 00 00 e0 Error: ICRC, ABRT at LBA = 0x00000000 = 0
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
25 00 01 6e d0 70 e0 00 00:01:00.392 READ DMA EXT
25 00 01 6d d0 70 e0 00 00:01:00.374 READ DMA EXT
00 00 01 00 00 00 00 04 00:01:00.366 NOP [Abort queued commands]
25 00 01 6d d0 70 e0 00 00:00:59.917 READ DMA EXT
25 00 01 6c d0 70 e0 00 00:00:59.900 READ DMA EXT
Error 112 occurred at disk power-on lifetime: 20352 hours (848 days + 0 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
84 51 00 00 00 00 e0 Error: ICRC, ABRT at LBA = 0x00000000 = 0
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
25 00 01 6d d0 70 e0 00 00:00:58.019 READ DMA EXT
25 00 01 6c d0 70 e0 00 00:00:58.019 READ DMA EXT
00 00 01 00 00 00 00 04 00:00:58.001 NOP [Abort queued commands]
25 00 01 6c d0 70 e0 00 00:00:59.917 READ DMA EXT
25 00 01 6b d0 70 e0 00 00:00:59.900 READ DMA EXT
Error 111 occurred at disk power-on lifetime: 20352 hours (848 days + 0 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
84 51 00 00 00 00 e0 Error: ICRC, ABRT at LBA = 0x00000000 = 0
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
25 00 01 6c d0 70 e0 00 00:00:58.019 READ DMA EXT
25 00 01 6b d0 70 e0 00 00:00:58.019 READ DMA EXT
00 00 01 00 00 00 00 04 00:00:58.001 NOP [Abort queued commands]
25 00 01 6b d0 70 e0 00 00:00:57.994 READ DMA EXT
25 00 01 6a d0 70 e0 00 00:00:57.544 READ DMA EXT
SMART Self-test log structure revision number 1
Num Test_Description Status Remaining LifeTime(hours) LBA_of_first_error
# 1 Short offline Completed without error 00% 22068 -
# 2 Short offline Completed without error 00% 20586 -
SMART Selective self-test log data structure revision number 1
SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS
1 0 0 Not_testing
2 0 0 Not_testing
3 0 0 Not_testing
4 0 0 Not_testing
5 0 0 Not_testing
Selective self-test flags (0x0):
After scanning selected spans, do NOT read-scan remainder of disk.
If Selective self-test is pending on power-up, resume after 0 minute delay.