Доброго времени суток.
Знаю, что данная тема обсуждалась энное количество раз, но перечитав большое количество тем ответа я так и не нашел.
Имеется 17и дюймовый монитор ACER AL1716 и Ubuntu 13.10 которая ну никак не хочет ставить разрешение 1280х1024.
Пробовал поменять разрешение через xrandr
xrandr
Screen 0: minimum 8 x 8, current 1024 x 768, maximum 8192 x 8192
DVI-I-0 disconnected (normal left inverted right x axis y axis)
DVI-I-1 connected primary 1024x768+0+0 (normal left inverted right x axis y axis) 0mm x 0mm
1024x768 60.0*+
1360x768 60.0 59.8
1152x864 60.0
800x600 72.2 60.3 56.2
680x384 60.0 59.8
640x480 59.9
512x384 60.0
400x300 72.2
320x240 60.1
TV-0 disconnected (normal left inverted right x axis y axis)
DVI-I-2 disconnected (normal left inverted right x axis y axis)
DVI-I-3 disconnected (normal left inverted right x axis y axis)
1280x1024_60.00 (0x288) 108.9MHz
h: width 1280 start 1360 end 1496 total 1712 skew 0 clock 63.6KHz
v: height 1024 start 1025 end 1028 total 1060 clock 60.0Hz
Далее.
cvt 1280 1024 60
# 1280x1024 59.89 Hz (CVT 1.31M4) hsync: 63.67 kHz; pclk: 109.00 MHz
Modeline "1280x1024_60.00" 109.00 1280 1368 1496 1712 1024 1027 1034 1063 -hsync +vsync
После чего создаю новый режим.
xrandr --newmode "1280x1024_60.00" 109.00 1280 1368 1496 1712 1024 1027 1034 1063 -hsync +vsync
С этого момента и начинает ругаться.
X Error of failed request: BadName (named color or font does not exist)
Major opcode of failed request: 140 (RANDR)
Minor opcode of failed request: 16 (RRCreateMode)
Serial number of failed request: 31
Current serial number in output stream: 31
Как еще можно изменить разрешение?