Mystex wrote
Устройство создалось, но теперь возникла другая проблема - не могу соединиться с инетом...
-------------------------------------
У меня Agere PCI Soft Modem
wvdial выдает следующее:
root@ubuntu:/home/yura # wvdial
--> WvDial: Internet dialer version 1.54.0
--> Initializing modem.
--> Sending: ATZ
ATZ
OK
--> Sending: AT S11=50
AT S11=50
OK
--> Modem initialized.
--> Sending: ATDT2342727
--> Waiting for carrier.
ATDT2342727
NO DIALTONE
--> No dial tone.
--> Disconnecting at Sat Aug 6 22:25:35 2005
Почему нет DIALTONE если в винде есть?
При попытке дозвониться через нетворк-админ вроде бы идет дозвон, но без конечного результата (модем шумит, но коннект не происходит)
Установил след. дрова ltmodem
root@ubuntu:/home/yura # dpkg -i ltmodem-3.6.8-1-686_8.31a8_i386.deb (Reading database ... 57181 files and directories currently installed.)
Preparing to replace ltmodem-2.6.8-1-686 8.31a8 (using ltmodem-3.6.8-1-686_8.31a8_i386.deb) ...
Unpacking replacement ltmodem-2.6.8-1-686 ...
Retaining lt_modem autoloading and device node support for kernel versions:
2.6.10-5-386
Setting up ltmodem-2.6.8-1-686 (8.31a8) ...
/var/lib/dpkg/info/ltmodem-2.6.8-1-686.postinst: line 96: gcc: command not found
Diagnostic information and Guidance is being written to /usr/share/doc/ltmodem-2.6.8-1-686/LTinstall.txt
UPDATE=2004_Sept_09
/usr/share/doc/ltmodem-2.6.8-1-686/utils/scanmodem: line 374: gcc: command not found
/usr/share/doc/ltmodem-2.6.8-1-686/utils/scanmodem: line 603: Modem/SoftModem.txt: No such file or directory
Providing detail for device at PCI_bus 0000:02:0c.0
with vendor-ID:device-ID
----:----
Class 11c1:048c (rev Communication controller: Lucent Microelectronics V.92 56K WinModem (rev 02)
SubSystem 11c1:044c Lucent Microelectronics: Unknown device 044c
0000:02:0c.0 0780: 11c1:048c (rev 02)
Flags: bus master, medium devsel, latency 32, IRQ 5
Memory at e6000000 (32-bit, non-prefetchable) [size=256]
I/O ports at a000 [size=8]
grep: /etc/modprobe.conf: No such file or directory
grep: /etc/modprobe.conf: No such file or directory
/usr/share/doc/ltmodem-2.6.8-1-686/utils/scanmodem: line 3010: exit0: command not found
/usr/share/doc/ltmodem-2.6.8-1-686/utils/scanmodem: line 3012: Modem/DriverCompiling.txt: No such file or directory
/usr/share/doc/ltmodem-2.6.8-1-686/utils/scanmodem: line 3161: syntax error near unexpected token `fi'
/usr/share/doc/ltmodem-2.6.8-1-686/utils/scanmodem: line 3161: `fi'
A PCI card modem was NOT detected, compatible with these drivers for
Lucent/Agere DSP (digital signal processing) chipsets.
The Agere Systems soft modem chipsets 11c1:048(a,b,c,d) and 11c1:0600 are NOT supported,
Nor are soft modem Subsystems under AC'97 or MC97 controllers.
But some supported ISA card and many PCMCIA modems
would not be detected by the scanmodem tool just used. Hence
the installation will continue in 10 seconds, unless aborted by: Ctrl-C
Modem device node is: /dev/ttyLT0
with access by members of the /etc/group dialout
Current membership is dialout:x:20:yura,cupsys,admin
The modem symbolic link is: /dev/modem --> /dev/ttyLT0
/etc/modprobe.d/ltmodem contains lines for autoloading the ltmodem driver.
grep: /etc/modules.conf: No such file or directory
grep: /etc/modules.conf: No such file or directory
Browse /usr/share/doc/ltmodem-2.6.8-1-686 for guidance and tools.
If not familar with the ltmodem drivers, run the interactive CHECKOUT utility by executing:
/usr/share/doc/ltmodem-2.6.8-1-686/utils/checkout
Вроде бы речь идет об отсутствии modules.conf. Явлсется ли это проблемой?
Тема: winmodem (Прочитано 14058 раз)
