virtualbox + ubuntu 10.04 & 12.04 x64

[djrust]

Есть windows 7 x64 ultimate(ноут с процом i7-2670Qm) на нем virtualbox
Устанавливаю ubuntu server 10.04 или 12.04 и не могу настроить сеть(((((

ifconfig -a

(Нажмите, чтобы показать/скрыть)

eth0      Link encap:Ethernet  HWaddr 08:00:27:e9:15:55
          inet addr:192.168.100.150  Bcast:192.168.100.255  Mask:255.255.255.0
          inet6 addr: fe80::a00:27ff:fee9:1555/64 Scope:Link
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:808 errors:0 dropped:0 overruns:0 frame:0
          TX packets:685 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:1000
          RX bytes:83418 (83.4 KB)  TX bytes:87384 (87.3 KB)

eth1      Link encap:Ethernet  HWaddr 08:00:27:7a:40:55
          inet addr:192.168.10.252  Bcast:192.168.10.255  Mask:255.255.255.0
          inet6 addr: fe80::a00:27ff:fe7a:4055/64 Scope:Link
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:0 errors:0 dropped:0 overruns:0 frame:0
          TX packets:58 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:1000
          RX bytes:0 (0.0 B)  TX bytes:7837 (7.8 KB)

lo        Link encap:Локальная петля (Loopback)
          inet addr:127.0.0.1  Mask:255.0.0.0
          inet6 addr: ::1/128 Scope:Host
          UP LOOPBACK RUNNING  MTU:16436  Metric:1
          RX packets:148 errors:0 dropped:0 overruns:0 frame:0
          TX packets:148 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:0
          RX bytes:15481 (15.4 KB)  TX bytes:15481 (15.4 KB)

route -n

Код: [Выделить]

Таблица маршутизации ядра протокола IP
Destination Gateway Genmask Flags Metric Ref Use Iface
192.168.100.0   0.0.0.0         255.255.255.0   U     0      0        0 eth0
192.168.10.0    0.0.0.0         255.255.255.0   U     0      0        0 eth1
0.0.0.0         192.168.100.1   0.0.0.0         UG    100    0        0 eth0

sudo cat /etc/resolv.conf

Код: [Выделить]

nameserver 127.0.0.1
sudo cat /etc/network/interfaces

Код: [Выделить]

# This file describes the network interfaces available on your system
# and how to activate them. For more information, see interfaces(5).

# The loopback network interface
auto lo
iface lo inet loopback

# The primary network interface
auto eth0
iface eth0 inet static
address 192.168.100.150
netmask 255.255.255.0
gateway 192.168.100.1

auto eth1
iface eth1 inet static
address 192.168.10.252
netmask 255.255.255.0
sudo cat /etc/bind/named.conf.options

Код: [Выделить]

options {
        directory "/var/cache/bind";

        // If there is a firewall between you and nameservers you want
        // to talk to, you may need to fix the firewall to allow multiple
        // ports to talk.  See http://www.kb.cert.org/vuls/id/800113

        // If your ISP provided one or more IP addresses for stable
        // nameservers, you probably want to use them as forwarders.
        // Uncomment the following block, and insert the addresses replacing
        // the all-0's placeholder.

         forwarders {
                91.144.184.3;
                91.144.186.3;
         };

        auth-nxdomain no;    # conform to RFC1035
        listen-on-v6 { any; };
};

sudo cat /var/log/syslog

(Нажмите, чтобы показать/скрыть)

May 19 11:46:36 mail named[1147]: received control channel command 'reconfig'
May 19 11:46:36 mail named[1147]: loading configuration from '/etc/bind/named.conf'
May 19 11:46:36 mail named[1147]: reading built-in trusted keys from file '/etc/bind/bind.keys'
May 19 11:46:36 mail named[1147]: using default UDP/IPv4 port range: [1024, 65535]
May 19 11:46:36 mail named[1147]: using default UDP/IPv6 port range: [1024, 65535]
May 19 11:46:36 mail named[1147]: reloading configuration succeeded
May 19 11:46:36 mail named[1147]: any newly configured zones are now loaded
May 19 11:46:36 mail dhclient: receive_packet failed on eth0: Network is down
May 19 11:46:36 mail named[1147]: received control channel command 'reconfig'
May 19 11:46:36 mail named[1147]: loading configuration from '/etc/bind/named.conf'
May 19 11:46:36 mail named[1147]: reading built-in trusted keys from file '/etc/bind/bind.keys'
May 19 11:46:36 mail named[1147]: using default UDP/IPv4 port range: [1024, 65535]
May 19 11:46:36 mail named[1147]: using default UDP/IPv6 port range: [1024, 65535]
May 19 11:46:36 mail named[1147]: reloading configuration succeeded
May 19 11:46:36 mail named[1147]: any newly configured zones are now loaded
May 19 11:46:36 mail kernel: [  679.997429] ADDRCONF(NETDEV_UP): eth0: link is not ready
May 19 11:46:36 mail kernel: [  680.000739] e1000: eth0 NIC Link is Up 1000 Mbps Full Duplex, Flow Control: RX
May 19 11:46:36 mail kernel: [  680.001712] ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready
May 19 11:46:36 mail named[1147]: received control channel command 'reconfig'
May 19 11:46:36 mail named[1147]: loading configuration from '/etc/bind/named.conf'
May 19 11:46:36 mail named[1147]: reading built-in trusted keys from file '/etc/bind/bind.keys'
May 19 11:46:36 mail named[1147]: using default UDP/IPv4 port range: [1024, 65535]
May 19 11:46:36 mail named[1147]: using default UDP/IPv6 port range: [1024, 65535]
May 19 11:46:36 mail named[1147]: reloading configuration succeeded
May 19 11:46:36 mail named[1147]: any newly configured zones are now loaded
May 19 11:46:36 mail init: ssh main process (1001) terminated with status 255
May 19 11:46:36 mail kernel: [  680.058910] ADDRCONF(NETDEV_UP): eth1: link is not ready
May 19 11:46:36 mail kernel: [  680.061478] e1000: eth1 NIC Link is Up 1000 Mbps Full Duplex, Flow Control: RX
May 19 11:46:36 mail kernel: [  680.062172] ADDRCONF(NETDEV_CHANGE): eth1: link becomes ready
May 19 11:46:36 mail named[1147]: received control channel command 'reconfig'
May 19 11:46:36 mail named[1147]: loading configuration from '/etc/bind/named.conf'
May 19 11:46:36 mail named[1147]: reading built-in trusted keys from file '/etc/bind/bind.keys'
May 19 11:46:36 mail named[1147]: using default UDP/IPv4 port range: [1024, 65535]
May 19 11:46:36 mail named[1147]: using default UDP/IPv6 port range: [1024, 65535]
May 19 11:46:36 mail named[1147]: reloading configuration succeeded
May 19 11:46:36 mail named[1147]: any newly configured zones are now loaded
May 19 11:46:36 mail init: ssh main process (1229) terminated with status 255
May 19 11:46:36 mail ntpdate[1224]: step time server 91.189.94.4 offset -0.088197 sec
May 19 11:46:41 mail ntpdate[1280]: step time server 91.189.94.4 offset -0.001786 sec
May 19 11:46:47 mail kernel: [  690.650029] eth1: no IPv6 routers present
May 19 11:46:47 mail kernel: [  690.750028] eth0: no IPv6 routers present

Кто устанавливал,в чем грабли?
Такие же настройки в x86 работают

[v!tax]

nat в настройках не пробовал включать?

[djrust]

nat в настройках не пробовал включать?

В настройках чего?

[лесной_зонтик]

в настройках виртуальной машины в virtualbox, в разделе сеть.

[djrust]

в настройках виртуальной машины в virtualbox, в разделе сеть.

АААА...у меня там сетевой мост!

[v!tax]

поставь NAT,должно работать.

[djrust]

не работает!

[v!tax]

машину перезапустил?

[djrust]

да! + поставил на eth0 получать настройки с dhcp
ping никуда не идет

Странно....пакеты качаются(а я на ping зациклился)

Ну да,links страницы грузит)

А чего такое с ping(om) то?
Есть подозрение на маршрутизатор,но на x86 такой проблемы нет(

traceroute ya.ru

Код: [Выделить]

traceroute to ya.ru (213.180.204.3), 30 hops max, 60 byte packets
 1  192.168.100.1 (192.168.100.1)  0.505 ms  0.587 ms  0.691 ms
 2  * bb0-vprn100.bsr05.nn.ertelecom.ru (91.144.184.77)  4.974 ms  10.388 ms
 3  ae-0-48.bgw01.nn.ertelecom.ru (91.144.184.169)  2.861 ms  14.577 ms  2.896 ms
 4  nnd02.transtelecom.net (217.150.49.122)  2.794 ms  2.727 ms  2.822 ms
 5  msk02.transtelecom.net (217.150.60.30)  10.068 ms  10.210 ms  11.128 ms
 6  Yandex-gw.transtelecom.net (217.150.60.29)  10.889 ms  9.504 ms  9.315 ms
 7  core-ugr-vlan901.yandex.net (77.88.56.126)  9.069 ms  8.840 ms  9.053 ms
 8  www.yandex.ru (213.180.204.3)  9.953 ms  10.423 ms  10.378 ms