установил control - при установке сказал - * Not starting fancontrol; run pwmconfig first.
pwmconfig -
# pwmconfig revision 6166 (2013-05-01)
This program will search your sensors for pulse width modulation (pwm)
controls, and test each one to see if it controls a fan on
your motherboard. Note that many motherboards do not have pwm
circuitry installed, even if your sensor chip supports pwm.
We will attempt to briefly stop each fan using the pwm controls.
The program will attempt to restore each fan to full speed
after testing. However, it is ** very important ** that you
physically verify that the fans have been to full speed
after the program has completed.
/usr/sbin/pwmconfig: There are no pwm-capable sensor modules installed
fancontrol -
Loading configuration from /etc/fancontrol ...
Error: Can't read configuration file
Пользователь решил продолжить мысль 21 Февраля 2015, 20:48:54:
Понял что мне нафиг не нужна эта инфа.Эсли до завтра нечего нового тему закрою.
Тема: команда sensors Не показывает скорость куллеров (Прочитано 1332 раз)
