Не могу завести SSD кардридер на ноутбуке HP 6910p

[beelesnik]

Преамбула: статью https://forum.ubuntu.ru/index.php?topic=10696.msg76635 читал.

Имеется ноутбук HP Compaq 6910. На нем Ubuntu 8.04.
Никак не получается завести карт-ридер для SD-карт, хотя sdricoh_cs-0.1.3 скомпилировался и поставился без ошибок. Ядро из официальных обновлений.

Вывод интересующих команд:

>>uname -a
Linux sergei-laptop 2.6.24-19-generic #1 SMP Fri Jul 11 23:41:49 UTC 2008 i686 GNU/Linux

>>lspci | grep Ricoh
02:06.0 CardBus bridge: Ricoh Co Ltd RL5c476 II (rev b9)
02:06.1 CardBus bridge: Ricoh Co Ltd RL5c476 II (rev b9)
02:06.2 FireWire (IEEE 1394): Ricoh Co Ltd R5C832 IEEE 1394 Controller (rev 03)
02:06.3 SD Host controller: Ricoh Co Ltd R5C822 SD/SDIO/MMC/MS/MSPro Host Adapter (rev 20)
02:06.4 System peripheral: Ricoh Co Ltd R5C843 MMC Host Controller (rev 10)

>>lsmod | grep mmc
mmc_core               51460  1 sdhci
ricoh_mmc               4352  0

После вставки карточки, судя по /var/log/messages ничего не происходит. Также ничего не происходит и после sudo modprobe mmc_block.

Может железяка какая-то невменяемая?

[ADL]

и dmesg молчит? 

Код: [Выделить]

$ lsmod | grep sd
что показывает

[beelesnik]

Вот вывод указанных команд:
1. :# lsmod | grep sd
sdhci                  19076  0
mmc_core               51460  1 sdhci
sd_mod                 30720  4
scsi_mod              151436  6 usb_storage,sbp2,sr_mod,sg,sd_mod,libata

2. dmesg (что касается Ricoh)

[   31.118013] Yenta: CardBus bridge found at 0000:02:06.0 [103c:30be]
[   31.247422] Yenta: ISA IRQ mask 0x0c38, PCI irq 18
[   31.247426] Socket status: 30000810
[   31.247430] pcmcia: parent PCI bridge Memory window: 0xe4100000 - 0xe43fffff
[   31.295271] Yenta: CardBus bridge found at 0000:02:06.1 [103c:30be]
[   31.374183] ricoh-mmc: Ricoh MMC Controller disabling driver
[   31.374187] ricoh-mmc: Copyright(c) Philip Langdale
[   31.422308] Yenta: ISA IRQ mask 0x0000, PCI irq 19
[   31.422313] Socket status: 30000810
[   31.422316] Yenta: Raising subordinate bus# of parent bus (#02) from #04 to #07
[   31.422321] pcmcia: parent PCI bridge Memory window: 0xe4100000 - 0xe43fffff
[   31.458418] ricoh-mmc: Ricoh MMC controller found at 0000:02:06.4 [1180:0843] (rev 10)
[   31.458434] ricoh-mmc: Controller is now disabled.
[   31.545275] sdhci: Secure Digital Host Controller Interface driver
[   31.545279] sdhci: Copyright(c) Pierre Ossman
[   31.545327] sdhci: SDHCI controller found at 0000:02:06.3 [1180:0822] (rev 20)
[   31.545352] ACPI: PCI Interrupt 0000:02:06.3 -> GSI 19 (level, low) -> IRQ 19
[   31.545374] sdhci:slot0: Will use DMA mode even though HW doesn't fully claim to support it.
[   31.545417] mmc0: SDHCI at 0xe4103000 irq 19 DMA

[dog_simpson]

неработает картридер
карточка - kingston sd 2gb
ноутбук - RoverBook voyager v551
ось - ubuntu 8.04
при втыкании карточки никаких действий не происходит

карточка рабочая, картридер рабочий, в виндусе работает


$ lsmod | grep sd 

sdhci                  19076  0
mmc_core               51460  1 sdhci
sd_mod                 30720  5
scsi_mod              151436  5 usb_storage,sg,sr_mod,sd_mod,libata

$ dmesg

[ 6180.105697] usb-storage: waiting for device to settle before scanning
[ 6185.100843] usb-storage: device scan complete
[ 6185.101877] scsi 4:0:0:0: Direct-Access     USB 2.0  Flash Disk       0.00 PQ: 0 ANSI: 2
[ 6185.104837] sd 4:0:0:0: [sdb] 8060927 512-byte hardware sectors (4127 MB)
[ 6185.105831] sd 4:0:0:0: [sdb] Write Protect is off
[ 6185.105842] sd 4:0:0:0: [sdb] Mode Sense: 00 00 00 00
[ 6185.105848] sd 4:0:0:0: [sdb] Assuming drive cache: write through
[ 6185.108711] sd 4:0:0:0: [sdb] 8060927 512-byte hardware sectors (4127 MB)
[ 6185.109329] sd 4:0:0:0: [sdb] Write Protect is off
[ 6185.109338] sd 4:0:0:0: [sdb] Mode Sense: 00 00 00 00
[ 6185.109343] sd 4:0:0:0: [sdb] Assuming drive cache: write through
[ 6185.109353]  sdb: unknown partition table
[ 6185.215244] sd 4:0:0:0: [sdb] Attached SCSI removable disk
[ 6185.215298] sd 4:0:0:0: Attached scsi generic sg2 type 0
[ 6211.558682] usb 5-6: USB disconnect, address 3
[ 6215.216876] usb 5-6: new high speed USB device using ehci_hcd and address 4
[ 6215.349439] usb 5-6: configuration #1 chosen from 1 choice
[ 6215.350032] scsi5 : SCSI emulation for USB Mass Storage devices
[ 6215.350679] usb-storage: device found at 4
[ 6215.350687] usb-storage: waiting for device to settle before scanning
[ 6220.346131] usb-storage: device scan complete
[ 6220.347126] scsi 5:0:0:0: Direct-Access     USB 2.0  Flash Disk       0.00 PQ: 0 ANSI: 2
[ 6220.350461] sd 5:0:0:0: [sdb] 8060927 512-byte hardware sectors (4127 MB)
[ 6220.351213] sd 5:0:0:0: [sdb] Write Protect is off
[ 6220.351224] sd 5:0:0:0: [sdb] Mode Sense: 00 00 00 00
[ 6220.351230] sd 5:0:0:0: [sdb] Assuming drive cache: write through
[ 6220.354201] sd 5:0:0:0: [sdb] 8060927 512-byte hardware sectors (4127 MB)
[ 6220.354827] sd 5:0:0:0: [sdb] Write Protect is off
[ 6220.354835] sd 5:0:0:0: [sdb] Mode Sense: 00 00 00 00
[ 6220.354840] sd 5:0:0:0: [sdb] Assuming drive cache: write through
[ 6220.354848]  sdb: unknown partition table
[ 6220.460743] sd 5:0:0:0: [sdb] Attached SCSI removable disk
[ 6220.460795] sd 5:0:0:0: Attached scsi generic sg2 type 0
[ 6235.648932] usb 5-6: USB disconnect, address 4
[ 6370.243543] mmc1: unrecognised SCR structure version 1
[ 6370.243566] mmc1: error -22 whilst initialising SD card
[ 6381.091537] mmc1: unrecognised SCR structure version 1
[ 6381.091558] mmc1: error -22 whilst initialising SD card
[ 6759.909750] mmc1: unrecognised SCR structure version 1
[ 6759.909774] mmc1: error -22 whilst initialising SD card
[ 6799.673200] mmc1: unrecognised SCR structure version 1
[ 6799.673216] mmc1: error -22 whilst initialising SD card

$ lsmod | grep mmc

mmc_block              14980  0
mmc_core               51460  2 mmc_block,sdhci

$  dmesg | tail

[ 6381.091537] mmc1: unrecognised SCR structure version 1
[ 6381.091558] mmc1: error -22 whilst initialising SD card
[ 6759.909750] mmc1: unrecognised SCR structure version 1
[ 6759.909774] mmc1: error -22 whilst initialising SD card
[ 6799.673200] mmc1: unrecognised SCR structure version 1
[ 6799.673216] mmc1: error -22 whilst initialising SD card
[ 7110.018114] mmc1: unrecognised SCR structure version 1
[ 7110.018136] mmc1: error -22 whilst initialising SD card
[ 7483.205773] ISO 9660 Extensions: Microsoft Joliet Level 3
[ 7483.267714] ISO 9660 Extensions: RRIP_1991A

/var/log/messages  также нет реакции на карту

что делать?

[dog_simpson]

никто незнает?

[dog_simpson]

$lspci
07:04.1 SD Host controller: ENE Technology Inc ENE PCI SmartMedia / xD Card Reader Controller