Как заставить работать? Читал на linmodems.org, но для меня это темный лес. Скачал с сайта длинк дрова под Linux. В архиве был мануал на инглише. Попытался сделать по мануалу, но так как с инглишем не очень.
6. DRIVER INSTALLATION
Prepare to install the drivers using the following sequence:
1.Log as root on the target Linux machine.
2.Find out the Vendor ID and Device ID of the PCI modem used and remember them (use the lspci command).
3.Copy the modem driver package file to the directory where you wish to extract it.
4.Extract the modem driver files from tar file
tar -xpvzf <tar-file-name>
This creates under the current directory the directory having the same name as the <tar-file-name> file, but without the .tar.gz suffix and extracts all files into it.
Example:
tar -xpvzf hsflinmodem-4.06.06.03.tar.gz
This creates the hsflinmodem-4.06.06.03 directory and extract modem driver files into it.
5.Change directory to the newly created directory
Example:
cd hsflinmodem-4.06.06.03
6.Update the Vendor ID and Device ID in the .inf file corresponding to the modem board used:
Check the list of the Microsoft Windows style PnP strings under the [Generic] section and if no string corresponds to your PCI modem Vendor ID and Device ID, add the appropriate string to the [Generic] section.
Example: If the Vendor ID is 1234 and the Device ID is 5678, add the line in red to the [Generic] section. The SUBSYS part is redundant for Linux modem drivers and can be omitted:
[Generic]
%HSFModem% = ModemX, PCI\VEN_14F1&DEV_2013&SUBSYS_201314F1
%HSFModem% = ModemX, PCI\VEN_14F1&DEV_2014&SUBSYS_201414F1
%HSFModem% = ModemX, PCI\VEN_14F1&DEV_2015&SUBSYS_201514F1
%HSFModem% = ModemX, PCI\VEN_14F1&DEV_2016&SUBSYS_201614F1
%HSFModem% = ModemX, PCI\VEN_1234&DEV_5678
The INF files are under the directory "inf"
After the INF file has been configured, follow these steps to build/load the modem:
1.CD to the directory in step 4 above, for example cd hsflinmodem-4.06.06.03
2.Run: make install.
3.Run: hsfconfig (If you have doubts on what to answer on one of the questions, press <enter> for the default answer).
4.During the installation you'll be asked to select your country, to change it after the installation is done, you can use at+gci .
5.The installation should be done only once (no need to install it again every time the machine is restarted).
The modem may now be tested with Minicom: minicom –s
Note: minicom application isn't a part of the standard linux installation.
Please see app note: KPPP Configurate Application Note for instructions on how to set up dial up networking in KDE.
Read the Install file in order to use the right installation script.
Тема: D-Link DFM-562IS и kubuntu 7.04 (Прочитано 1491 раз)
