не всё задание понял,вот что смог найти похожего=копировалось на флешку в виде текстового файла. В винде получилась каша из цифр и букв,возможно специалист разберётся что к чему,извините,по-другому не получается
sudo ifconfig -a =
ubuntu@ubuntu:~$ sudo ifconfig -a
eth0 Link encap:Ethernet HWaddr 00:02:3f:b3:e3:14
UP BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 B) TX bytes:0 (0.0 B)
Interrupt:11 Base address:0x3000
eth1 Link encap:Ethernet HWaddr 00:0e:35:59:2f:ce
inet addr:192.168.1.2 Bcast:192.168.1.255 Mask:255.255.255.0
inet6 addr: fe80::20e:35ff:fe59:2fce/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:88 errors:0 dropped:0 overruns:0 frame:0
TX packets:20 errors:0 dropped:4 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:17861 (17.8 KB) TX bytes:4260 (4.2 KB)
Interrupt:11 Memory:e0204000-e0204fff
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:80 errors:0 dropped:0 overruns:0 frame:0
TX packets:80 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:6144 (6.1 KB) TX bytes:6144 (6.1 KB)
pan0 Link encap:Ethernet HWaddr f2:9f:a1:76:af:b9
BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:0 (0.0 B) TX bytes:0 (0.0 B)
vboxnet0 Link encap:Ethernet HWaddr 0a:00:27:00:00:00
BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 B) TX bytes:0 (0.0 B)
============================================
sudo route
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use Iface
192.168.1.0 * 255.255.255.0 U 2 0 0 eth1
link-local * 255.255.0.0 U 1000 0 0 eth1
-------------------------------------------------------------
resolv.conf
# Generated by NetworkManager
============================
75-persistent-net-generator=
# do not edit this file, it will be overwritten on update
# these rules generate rules for persistent network device naming
#
# variables used to communicate:
# MATCHADDR MAC address used for the match
# MATCHID bus_id used for the match
# MATCHDRV driver name used for the match
# MATCHIFTYPE interface type match
# COMMENT comment to add to the generated rule
# INTERFACE_NAME requested name supplied by external tool
# INTERFACE_NEW new interface name returned by rule writer
ACTION!="add", GOTO="persistent_net_generator_end"
SUBSYSTEM!="net", GOTO="persistent_net_generator_end"
# ignore the interface if a name has already been set
NAME=="?*", GOTO="persistent_net_generator_end"
# device name whitelist
KERNEL!="eth*|ath*|wlan*[0-9]|msh*|ra*|sta*|ctc*|lcs*|hsi*", GOTO="persistent_net_generator_end"
# ignore Xen virtual interfaces
SUBSYSTEMS=="xen", GOTO="persistent_net_generator_end"
# read MAC address
ENV{MATCHADDR}="$attr{address}"
# match interface type
ENV{MATCHIFTYPE}="$attr{type}"
# These vendors are known to violate the local MAC address assignment scheme
# Interlan, DEC (UNIBUS or QBUS), Apollo, Cisco, Racal-Datacom
ENV{MATCHADDR}=="02:07:01:*", GOTO="globally_administered_whitelist"
# 3Com
ENV{MATCHADDR}=="02:60:60:*", GOTO="globally_administered_whitelist"
# 3Com IBM PC; Imagen; Valid; Cisco; Apple
ENV{MATCHADDR}=="02:60:8c:*", GOTO="globally_administered_whitelist"
# Intel
ENV{MATCHADDR}=="02:a0:c9:*", GOTO="globally_administered_whitelist"
# Olivetti
ENV{MATCHADDR}=="02:aa:3c:*", GOTO="globally_administered_whitelist"
# CMC Masscomp; Silicon Graphics; Prime EXL
ENV{MATCHADDR}=="02:cf:1f:*", GOTO="globally_administered_whitelist"
# Prominet Corporation Gigabit Ethernet Switch
ENV{MATCHADDR}=="02:e0:3b:*", GOTO="globally_administered_whitelist"
# BTI (Bus-Tech, Inc.) IBM Mainframes
ENV{MATCHADDR}=="02:e6:d3:*", GOTO="globally_administered_whitelist"
# Realtek
ENV{MATCHADDR}=="52:54:00:*", GOTO="globally_administered_whitelist"
# Novell 2000
ENV{MATCHADDR}=="52:54:4c:*", GOTO="globally_administered_whitelist"
# Realtec
ENV{MATCHADDR}=="52:54:ab:*", GOTO="globally_administered_whitelist"
# Kingston Technologies
ENV{MATCHADDR}=="e2:0c:0f:*", GOTO="globally_administered_whitelist"
# match interface dev_id
ATTR{dev_id}=="?*", ENV{MATCHDEVID}="$attr{dev_id}"
# do not use "locally administered" MAC address
ENV{MATCHADDR}=="?[2367abef]:*", ENV{MATCHADDR}=""
# do not use empty address
ENV{MATCHADDR}=="00:00:00:00:00:00", ENV{MATCHADDR}=""
LABEL="globally_administered_whitelist"
# build comment line for generated rule:
SUBSYSTEMS=="pci", ENV{COMMENT}="PCI device $attr{vendor}:$attr{device} ($driver)"
SUBSYSTEMS=="usb", ATTRS{idVendor}=="?*", ENV{COMMENT}="USB device 0x$attr{idVendor}:0x$attr{idProduct} ($driver)"
SUBSYSTEMS=="pcmcia", ENV{COMMENT}="PCMCIA device $attr{card_id}:$attr{manf_id} ($driver)"
SUBSYSTEMS=="ieee1394", ENV{COMMENT}="Firewire device $attr{host_id})"
# ibmveth likes to use "locally administered" MAC addresses
DRIVERS=="ibmveth", ENV{MATCHADDR}="$attr{address}", ENV{COMMENT}="ibmveth ($id)"
# S/390 uses id matches only, do not use MAC address match
SUBSYSTEMS=="ccwgroup", ENV{COMMENT}="S/390 $driver device at $id", ENV{MATCHID}="$id", ENV{MATCHDRV}="$driver", ENV{MATCHADDR}=""
# see if we got enough data to create a rule
ENV{MATCHADDR}=="", ENV{MATCHID}=="", ENV{INTERFACE_NAME}=="", GOTO="persistent_net_generator_end"
# default comment
ENV{COMMENT}=="", ENV{COMMENT}="net device ($attr{driver})"
# write rule
DRIVERS=="?*", IMPORT{program}="write_net_rules"
# rename interface if needed
ENV{INTERFACE_NEW}=="?*", NAME="$env{INTERFACE_NEW}"
LABEL="persistent_net_generator_end"
При попытке править в конфигах и рулесах выкидывает сообщение,типо нет доступа. Так как файлы только для чтения. Не сообразил,чем их можно открыть для правки с правами рута,да еще и сохранить изменения... Замучили эти посылы системы типа иди ты.... Даже "сохранить как" не даёт заяза